Painting Like the Pros: Interior

If you proceed logically through the steps below, soon you will be painting like the pros. Be sure to read the instructions on the paint can label for information specific to the product you are using. Your retailer also has a product manual with complete specifications.

Start out the easy way
Always start with the ceiling. Follow with the walls, then the windows, trim and doors.

Begin brushing
Dip bristles one third of their length into the paint and tap gently against the inside edge of can or pail to release excess. Try not to drag the brush across edge of can. Holding the brush near the ferrule, use light strokes with slight pressure from your fingertips. This helps eliminate lap marks. Always use a quality brush designed for the type of paint you are using.

Rolling
Work paint into the roller by moving it back and forth in the deep end of the tray. Make sure it is distributed evenly and remove excess by rolling lightly across ridges at shallow end of tray. Work the roller in slow, smooth strokes to prevent bubbles or spattering.

Ceiling
Begin by brushing a hand-wide strip around the perimeter of the room where the walls meet the ceiling. Then roll paint in one-metre strips across the shortest width of the ceiling. Avoid lapping by maintaining a wet edge. Here is how: when reapplying a loaded roller to a surface, first place it on an unpainted area of the strip. Then work backwards into the strip of wet paint. This will eliminate the risk of seeing lines where one strip ends and the next begins.

Wall to wall
Work in approximately one metre segments from the top down. When using a roller, lay initial paint on in a broad M pattern starting at the bottom of the letter. Then even out by rolling lightly with horizontal strokes followed by vertical strokes.

Windows
Open slightly at top and bottom and paint inner sash. Finish with frame and sill.

Doors
Paint frame first, then top and side edges. On panelled doors, paint mouldings and panels starting at the top and working across and down sequentially. Finish by painting areas surrounding panels from the top down. Treat flush doors the same as walls.

Trim
Gloss and semi-gloss paints require less brush pressure than flat paints. Complete small areas at a time, brush with even strokes. Never try to touch up a spot that has begun to set. A plastic shield for the floor or wall is handy when painting trim. Remember, if you are not sure how to paint a particular area, your Benjamin Moore Retailer would be more than happy to answer your questions.

**Courtesy of Benjamin Moore Paints - www.benjaminmoore.ca